1 Select COM Port
Connect your device to this computer using the included USB Config Cable, then click Scan Ports.
Make sure the USB driver is installed first. On Windows 11, if the port still doesn't appear: How to fix โ†’
2 Connect Device
Make sure your device is powered on (blue LED should be on) before connecting.
Not connected
Select a COM port above, then click Connect.
3 Configure & Apply
Setup
Advanced
Device Info
Network
SIM, server and regional band settings
APN
Confirm APN with your SIM card provider โ€” an incorrect APN may prevent the device from connecting to the network.
APN cannot be empty.
Server & Port
Supports both domain name and IP address.
Region / Network Mode
๐ŸŒ
Global
Europe ยท Asia ยท Africa
๐Ÿ‡บ๐Ÿ‡ธ
USA / Canada
LTE-M only
๐Ÿ‡ฆ๐Ÿ‡บ
Australia / NZ
LTE-M ยท Band 28
๐Ÿ“ถ NWM,0,0,2 + BAND,0,0,f โ€” LTE-M with 2G fallback, auto band
Working Mode
How often the device reports its location
First time? Use Mode 1 (Real-time). Other modes may sleep when not moving, which can look like a malfunction.
Mode 1 โ€” Real-time Recommended for testing
๐Ÿ“ก Continuous tracking. Device always reports at fixed interval.
Interval
sec
(10 โ€“ 600 sec)
Mode 3 โ€” Ultra Low Power
๐Ÿ”‹ Maximum battery life. Best for long-term asset tracking.
Mode 7 โ€” Smart Low Power
โšก Reports when moving (T1), sleeps when stationary (T2). Recommended for most use cases.
Mode 0 โ€” Mix Mode Slightly higher power than Mode 7
โšก Active when vibrating (T1), low-power when still (T2).
Need a different mode? Use Advanced โ†’ Advanced Command to enter a MODE command directly. Mode guide โ†’
Debug Mode
Verbose logging for testing โ€” increases power use
Enable debug output
Disable after testing to save battery.
Advanced Command
Send a raw command directly to the device
ETS session must be active. Working mode commands will trigger auto-save and reboot.
Danger Zone
Irreversible โ€” erases all settings
Restores the device to factory defaults. This cannot be undone.
Device Information
Current configuration read from the device
Connect your device and click Read Device to load current settings.
Communication Log
โ€” Ready. Connect your device to begin. โ€”
Help Shop Forum mictrack.com
Applying Configurationโ€ฆ
1
Waking up device
โ€”
2
Setting APN
โ€”
3
Setting server address
โ€”
4
Setting network mode
โ€”
5
Setting network band
โ€”
6
Setting debug mode
โ€”
7
Setting working mode
โ€”
Factory Reset
This will erase all settings and restore factory defaults. This cannot be undone.
Import Commands